NorthStar Battery Chargers by C-TEK are high performance, multi-step, fully automatic primary switch mode chargers for batteries that can support fast charging. With these chargers, you can recharge a discharged NorthStar battery in 3 hours or less.

Unlike traditional battery chargers, CTEK chargers are designed with a focus on simplicity, safety and flexibility. The new chargers are weather resistant, with unique Supply and Recond modes, and a patented de-sulfation function. CTEK has sold over 4 million battery chargers in 60 countries around the world, and has won more than 15 independent battery charger tests since 2005.

Contact our team of specialists at 860.243.0646 or sales@midstatebattery.com for more information about these innovative battery chargers!

NSBC 7

Technical Data:

Charging Voltage: 14.4/14.7/15.8/13.6 V
Charging Current: Max 7 A
Type of Charger: 8 step, fully automatic charging cycle
Type of Battery: 12 V lead-acid batteries
Battery Capacity: 14-150 Ah, up to 225 Ah for maintenance
Insulation: IP65 (splash and dust proof)

  • Fully automatic charging and maintenance in 8 steps maximizes battery life and performance
  • Numerous accessories simplifies using the same charger for multiple batteries
  • Water-resistant so that the solution could be taken to the problem even if it rains or snows
  • Power Supply that simplifies battery replacement without losing vehicle memory
  • Patented maintenance charge for a unique combination of maximized life and performance
  • Recondition of deep discharged batteries
  • Patented de-sulphation that extends the battery life
  • No sparks, short-circuit proof and reverse-polarity protected for untroubled usage
  • Automatic detection of end-of-life batteries that eliminates surprises

NSBC 25

Technical Data:

Charging Voltage: 14.4/15.8/13.6 V
Charging Current: Max 25 A
Type of Charger: 8 step, fully automatic charging cycle
Type of Battery: 12 V lead-acid batteries
Battery Capacity: 40-500 Ah, up to 500 Ah for maintenance
Insulation: IP44 (outdoor use)

  • Temperature compensated and fully automatic charging and maintenance in 8 steps maximizes battery life and performance
  • Power Supply that simplifies battery replacement without losing vehicle memory
  • Patented maintenance charge for a unique combination of maximized life and performance
  • Recondition of deep discharged batteries
  • Patented de-sulphation that extends the battery life
  • No sparks, short-circuit proof and reverse-polarity protected for untroubled usage
  • Automatic detection of end-of-life batteries that eliminates surprises

NSBC 250

Technical Data:

Charging Voltage: 14.4 V
Charging Current: Max 20 A
Type of Charger: 5 step, fully automatic charging cycle
Type of Battery: 12 V lead-acid batteries
Battery Capacity: 40-300 Ah
Insulation: IP65 (splash and dust proof)

 

Features:

  • Multi-step charging from alternators and solar panels
  • Battery separator that eliminates diodes and VSR relays
  • Maintenance charge of starter battery
  • Solar panel regulator with Maximum Power Point Tracking, synchronized with other current sources such as the alternator and/or wind
  • Simplified installation of remote batteries for bow thrust of anchor winch

Benefits:

  • Maximized battery life due to minimized undercharge time
  • Maximized battery capacity when the battery is kept fully charged avoiding harmful sulphate crystals on the lead plates and stratification of the battery acid.
  • Ability to take charge automatically from any power source that is connected to the NSBC 250
  • Reduced charging times and costs by decreasing engine idling and the dependency on AC power onshore through efficient use of alternator and solar power
  • Reduced environmental impact through extended battery life and a reduced idle time
  • Minimal installation time and cost

NSBC SMARTPASS

Technical Data:

Charging Current: 80A
Type of Battery: 12 V lead-acid batteries
Battery Capacity: 75-800 Ah
Insulation: IP65 (splash and dust proof)
Part No.: 56-676

 

Features:

  • Battery separation eliminates diodes and VSR relays
  • Charging of service batteries up to 80A, reducing recharge time
  • Separation of energy-consuming equipment and service batteries during charging increasing the expected life of 12V devices such as light bulbs, LEDs and other electronics. Allows the battery to be charged from the alternator at a level that minimizes recharge time [patent pending]
  • Temperature protection of services batteries reduces charge current at high temperatures [patent pending]

Benefits:

  • Maximized battery life as a result of reduced incidences where the battery is undercharged
  • Reduced charging times and costs by decreasing engine idling
  • Reduced dependency on AC power onshore through efficient use of alternator and solar power
  • Reduced environmental impact through extended battery life and a reduced idle time
  • Minimal installation time and cost

 

Download Product Specs:

 

 

Looking for more information? Do you have questions about these products?

Call Midstate Battery today at (860) 243-0646 to speak with one of our battery specialists!